3608 Generator Set (Medium Speed)

3608 Generator Set (Medium Speed)

Bore 11 in
Displacement 1,127 in3
Stroke 12 in
Aspiration TA
Fuel System Direct unit injection
Minimum Rating 1830 ekW
Engine Specifications
Bore 11 in
Displacement 1,127 in3
Stroke 12 in
Aspiration TA
Fuel System Direct unit injection
Engine Model 3608 I-8,4-Stroke Water-Cooled Diesel
Total Displacement 9,064 in³
Compression Ratio 13:01
Governor Type Generator Set Monitoring System (GMS)
Aspiration TA
Fuel System Direct unit injection
Bore 11 in
Displacement 9,064 in³
Stroke 12 in
Fuel System 9,064 in³
Generator Set Specifications
Minimum Rating 1830 ekW
Maximum Rating 2660 ekW
Frequency 60 Hz
Speed 720 & 900 rpm
Emissions/Fuel Strategy Low Fuel Consumption
Duty Cycle Standby, Prime, Continuous
Generator Set Dimensions
Length - Maximum 404 in
Width - Maximum 100 in
Height - Maximum 157 in
Dry Weight - Genset (maximum) 91,050 lb

Cat Diesel Engine

Generator

World Wide Product Support

Full Range of Attachments

  • Air Inlet System
    • Aftercooler, fresh water, corrosion resistant coated (air side)
    • Air inlet shutoff
    • Turbocharger, watercooled (720 rpm and HFO), engine oil lubricated
    • Breather, crankcase, top-mounted
  • Cooling System
    • Engine coolant water drains
    • Water temperature regulator
    • Jacket water thermostats
  • Exhaust System
    • Includes adapter, Flexible exhaust fitting
    • 457 mm (18 in) Cat bolt pattern
    • Dry, gas tight, exhaust manifold
  • Fuel System
    • Simplex or Duplex
  • Generator System
    • Custom generator per generator data sheet completed by dealer
  • Governor System
    • UG Actuator
  • Lube System
    • Oil filler and dipstick
    • Service side engine mounted on cylinder block inspection covers
    • Wet oil sump. Includes engine-driven main lubrication & oil pumps, Oil Lines and Oil Pan
    • Centrifugal oil filters with single shutoff
    • Oil pressure regulating valve
    • Crankcase explosion relief valves
  • Mounting System
    • Engine and generator mounting
    • Damper, torsional vibration
  • Starting / Charging System
    • Air silencer
    • One motor, engine mounted at rear, on left side
    • Vane type air starter
    • Line group for single point custom connection
  • General:
    • Gear driven pumps: Fuel, Oil, Jacket water, Aftercooler / Oil cooler water
    • Paint, Caterpillar yellow
  • Air Inlet System
    • Heavy duty air cleaner
    • Air inlet adapter
    • Boost control valve
    • Air cleaner louver assembly
    • Vertical support bracket
    • Soot filter
  • Cooling System
    • Auxiliary water pump
    • Heating aids
    • Cooling system aids
    • Expansion tank
  • Exhaust System
    • Weld flange and related hardware
    • Flexible exhaust fittings
  • Fuel System
    • Fuel priming pump
    • Duplex primary fuel strainer
    • Fuel system connections
  • Generator System
    • Class F insulation
    • Anti-condensation space heaters
    • 3 Phase, six Leads, WYE
    • Winding temperature detectors
    • Busbar connections
  • Governor System
    • Battery backup / Power supply
    • 2301 A load share
    • Electronic / actuators
    • Digital programmers
    • EGB actuator
    • 723 Plus
  • Lube System
    • Lube ANSI adapter (Emergency connection)
    • Oil pan drain valve
  • Mounting System
    • Spring type vibration isolator
    • Non-vertically restrained
    • Vertically restrained
    • Isolator
  • Starting / Charging System
    • Pressure reducing valve
    • Compressed air flex hose
  • General:
    • Custom paint colors
×